The line conditioner is an essential part of a hi end system, since it enables each component of the system to achieve always its maximum performances, under any condition.
The CZ-3000 line conditioner performs the following functions:
Filtering of the power supply
A specially designed low-pass filter ensures an attenuation of 28 dB @ 1 KHz and then increasing to 60 dB at 100 KHz ÷ 1 MHz.
An insulating transformer, largely oversized, has four separate secondary coils for four output sockets. In this way a galvanic insulation of the units connected to the conditioner from the mains and each other is achieved. Additionally the ground loops are eliminated.
Each individual outlet is equipped with its own filter, optimized to eliminate the noises in the highest frequencies. As a result, a very efficient de-coupling of the units among themselves, and a very good overall protection against the noises of any frequency are achieved.
The voltage at the four galvanically insulated sockets is stabilized with a precision of ±2.5%, when the input voltage is in the range of ±10%.
A display on the front panel shows the input and output voltage. An electronic device disconnects the output sockets when the input voltage goes out of tolerance ±13%, so protecting the equipment.
A special device protects the conditioner’s circuits from overvoltage.
Four of the six output sockets are stabilized and insulated from the mains and among themselves by the insulating transformer.
One of them supplies 175 VA; the other three sockets supply 100 VA each.
Finally the two not insulated sockets (but filtered anyway) can supply 3000 VA in total.